Top-rated independent appliance repair across the Southeast
Built-In Microwave Repairs
If your built-in microwave quit heating, sticks at the latch, or spins the turntable while dinner stays cold, we'll diagnose it and tell you whether it's worth repairing. Built-ins aren't countertop units. They're framed into cabinetry and trimmed to fit, so swapping one can turn into carpentry. Here's how we sort it out.
Call (888) 826-9217- A real person answers
- Open 7 days
- Written quote before work starts
Taking calls until 5:00 PM ET
By our service team · vetted by the techs who do this daily
Age matters, but not the way you think
A built-in that's five or six years old is usually worth fixing. Past ten, we get more careful. The question isn't only years. It's whether the unit was a heavy-duty model or a builder-grade filler. Cabinet cutouts age poorly too. Older openings often don't match current sizes, so replacement drags in trim work, filler kits, or a cabinet maker, and that changes the math fast. We'd rather repair a decade-old unit that fits its hole perfectly than start a remodel over a bad door switch. Tell us the model number when you call us. It tells us a lot before we ever load the van.
The fault tells the story
Some failures are routine. Door switches, latches, control panels, cooling fans, turntable motors, and burned wiring connections are common and fixable. A unit that runs but won't heat often points to a single component, and we test that safely with the power off and the unit discharged. Other faults are heavier. A failed transformer plus scorched wiring plus a cracked cavity liner adds up. Rust burned through the cavity floor, or arcing that pitted the interior walls, means the box itself is compromised. Sparking inside is a stop-now symptom. Unplug it or kill the breaker and let us look before you use it again.
Whether parts still exist
Parts availability decides more calls than anything else. Control boards for discontinued models go scarce, and some manufacturers stop stocking them entirely. Generic parts don't exist for proprietary boards. When we can source the part, repair usually makes sense. When it's backordered with no date, we say so plainly rather than let your kitchen sit dead for weeks. Trim kits are their own headache. Atlanta metro homes span decades of kitchen styles, and matching a discontinued trim to your cabinet opening is sometimes harder than finding the electronics. We check part status during the visit and give you a straight answer.
What we actually do on the visit
We start with your description, then run the unit if it's safe to. We check door alignment and latch action, look for scorching or arc marks in the cavity, listen to the fan and magnetron cycle, and read fault codes where the control offers them. Over-the-range models get a vent path check too, since grease-clogged filters and blocked ducts cook the electronics. Humidity here is rough on control boards, so we inspect connections for corrosion. Then we tell you the fault, whether the part is available, and how long it takes. You decide from there. No pressure either direction.
When replacing is the honest answer
Sometimes we recommend swapping. A cavity with rust holes or arc damage can't be made safe. Multiple major failures at once on an older unit rarely ends well. A discontinued board with no supply chain is a dead end, and stringing you along helps nobody. Units that took water damage from an upstairs leak are usually finished. We'll also flag it if a repair would only buy a few months given the unit's overall condition. When that's the case, we say it, note the cutout dimensions you'll need for shopping, and step out of the way. Call us and we'll take a look.
When it is time to book
Related guides
Built-In Microwave Repairs — fast answers
My microwave runs but food stays cold. Is that fixable?
Often yes. That symptom usually points to a specific heating component or a door switch, not the whole unit. We test it safely with power off. If the part is available, it's a straightforward repair.
Can I keep using a microwave that sparked inside?
No. Stop using it and unplug it or shut off the breaker. Sparking means arcing, which can pit the cavity walls or damage the waveguide cover. Have it inspected before it runs again.
Do I have to replace the cabinet if the microwave is replaced?
Not always, but it's a real risk. Cutout sizes changed over the years, so a new unit may need a filler or trim kit. We measure your opening and tell you what you're dealing with.
How it works
- Step 1
Tell us the symptom
Call us or fill out the form. Describe what the machine is doing: the noise, the smell, the error code. Brand and rough age help us load the right parts.
- Step 2
We schedule a window
Metro Atlanta traffic is real, so we book arrival windows that hold up. You get a heads-up before the technician rolls out, and we work around your day where routes allow.
- Step 3
Diagnose, then repair
The technician tests the unit, finds the failed part, and explains what's wrong in plain words. You approve the work before anything gets replaced. Most common parts ride on the van.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- Built for Southern humidityDamp air punishes appliances. Dryers take longer, gaskets grow mildew, ice makers sweat and freeze up. We see these patterns weekly, so we check for them instead of chasing the obvious part first.
- Pollen-season know-howSpring coats every condenser coil in yellow film. A fridge that struggles in April often just can't shed heat. We clean it, test airflow, and tell you what actually failed versus what was choked.
- Six states, one teamGeorgia and the states around it. Same intake and same diagnostic approach whether you're inside the Perimeter or two hours out, with the same clear explanation at the end. One call reaches the whole service area.
- All major brands, independentWe are not tied to any manufacturer. We service what's in your kitchen and laundry room regardless of badge, and any repair-or-replace recommendation comes from the machine itself, not a brand relationship.
- All major brands, gas & electricOne independent crew for Whirlpool, Samsung, GE, LG, Maytag, Bosch and more.
- Straight answersNot worth fixing? We say that out loud, and often it saves you the visit fee.
About this guide
Past the safe checks, it's a job for tools and a meter
Report what you saw during the checks and we handle the rest. A minute to book.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →